Operating Modes; Technical Data; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL Bavaria BWS 125/850-3 Instructions De Service

Masquer les pouces Voir aussi pour BWS 125/850-3:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Anleitung BWS_125_850_3_SPK1:_

OPERATING MODES

Rough grinding:
For the best rough grinding results, hold the grinding
wheel at an angle of between 30° and 40° to the
workpiece surface and guide back and forth over the
workpiece in steady movements.
Cutting:
When you use the right-angle grinder for cutting
purposes, avoid tilting it in the cutting plane. The
cutting wheel must have a clean cutting edge.
A diamond cutting wheel is best used to cut hard
stone.
It is prohibited to use the machine on asbestos
materials!
Never use a cutting wheel for rough grinding.

TECHNICAL DATA

Nominal voltage:
230 V ~ 50 Hz
Power consumption:
Idle speed:
11.000 rpm
Max. wheel diameter:
Drive spindle thread:
Sound pressure level L
:
pA
Sound power level L
:
WA
Vibration a
hv
Weight
Totally insulated
Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
15.05.2007
16:13 Uhr
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
850 W
125 mm
M 14
89,6 dB
102,6 dB
5,53 m/s
2
1,8 kg
II /
Seite 7
GB
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

44.303.10

Table des Matières