Power Supply Cord—All Models
NOTE: The air conditioner's power supply cord may differ from
those shown.
The air conditioner is equipped with a power supply cord that is
required by UL. This power supply cord contains
state-of-the-art electronics that sense leakage current. If the cord
is damaged, the electronics detect leakage current and power
will be disconnected in a fraction of a second.
To test your power supply cord:
1. Plug power supply cord into a grounded 3 prong outlet.
2. Press RESET (on some models, a green light will turn ON).
3. Press TEST (listen for click; Reset button will trip, and on some
devices, a green light will turn OFF).
4. Press and release RESET (listen for click; Reset button will
latch, and on some devices, a green light will turn ON). The
power supply cord is ready for operation.
NOTES:
The Reset button must be pushed in for proper operation.
■
The power supply cord must be replaced if it fails to trip when
■
the test button is pressed or fails to reset.
Do not use the power supply cord as an OFF/ON switch. The
■
power supply cord is designed as a protective device.
A damaged power supply cord must be replaced with a new
■
power supply cord obtained from the product manufacturer
and must not be repaired.
The power supply cord contains no user-serviceable parts.
■
Opening the tamper-resistant case voids all warranty and
performance claims.
4
Tools Required—All Models
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Phillips screwdriver
Tape measure
Cordless drill
and 3/16" bit
Flathead screwdriver
Packing List
IMAGE
Through-The-Wall Air Conditioner
Remote Control
or
Trim Frame 1 (Left&Right legs)
Trim Frame 2 (Top&Bottom legs)
Grille Aluminum
Rear plastic net
1/2" Long Hex-head Screw
Grounding wire with tooth washer
Scissors
Level
Pencil
PART
QUANTITY
1
1
2
2
1
1
4
1