Care And Maintenance - Ryobi RSH2400R Manuel D'utilisation

GB
F D E
WARNING!
When feeding long woody branches/stems into
the shredder be careful of whip and vibrations as
they get caught by the cutter.
WARNING!
The cutting device has a tendency to pull
branches/stems into the machine. Do not try
to impede entry of the material being cut once
feeding has started.
If necessary, use the plunger provided to push the waste
material down into the feeding chute.
NOTE:In normal use, do not switch off the garden
shredder until all of the shredded material has cleared
the cutter assembly. If the garden shredder is switched
off too quickly, remaining pieces of material may clog the
blade assembly and stall the motor when the shredder is
switched back on.

CARE AND MAINTENANCE

REVERSING THE BLADE
(see figure 9 figure 11 figure 12 )
1. Switch off shredder by pressing the power On/Off
switch to OFF position.
2. Disconnect the shredder from the mains power supply.
3. Unscrew cover using locking knob. (Can refer to the
paragraph: CLEARING OBSTRUCTIONS)
4. Wearing protective glover, using Spanner I (with hex
key) provided unscrew the cutting blade screw A from
the cutting device (see figure 11)
5. Rotation the cutting blade plate make the screw B can
unscrew by safe blockage hole, and using Spanner
I (with hex key) provided unscrew the cutting blade
screw B from the cutting device (see figure 12)
6. Remove cutting blade, and rotate blade 180 so the
new blade cutting edge is now in use.(see figure 12)
7. Follow the above procedure for the opposite cutting
blade.
8. Assemble the safe blockage, and using spanner II to
tight the screws
9. Ensure all hex screw is fully tightened.
10. Finally return cover, making sure cover is correctly
located and securely re-tighten locking knob.
NOTE: If cover is not correctly fitted and locking knob not
securely tightened the shredder will not operate.
I P NL S DK N FIN GR HU CZ RU
English
1. To ensure the best performance from the garden
shredder, it must be kept clean.
2. Always clean the garden shredder immediately after
use.
3. Do not allow material to become dry and hard on any
of the garden shredder surfaces. This will directly
affect the shredding performance.
4. Make sure that the feeder chute and the ejection chute
are kept clean and clear of all waste material.
5. Make sure that all nuts, bolts and screws are tight and
secure.
6. Always have any damaged or worn parts repaired, or
replaced by qualified personnel.
CAUTION
1. Do not over tighten the plate adjustment screw and
cut excessive aluminum off of the plate, as this will
reduce the life of your shredder.
2. Have your garden shredder inspected and maintained
by qualified service personnel. Do not attempt to
repair the machine unless you are qualified to do so.
STORAGE
Make sure that the garden shredder has been thoroughly
cleaned before storing it in a clean, dry place out of the
reach of children.
15
RO PL SLO HR TR EST LT
MAINTENANCE
WARNING!
Before commencing cleaning and maintenance
procedures, make sure the garden shredder is
switched off and disconnected from the mains
supply. Always wear sturdy leather gloves when
cleaning the cutter blades.
LV SK BG