Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When the lock button is in the locked position , the
switch cannot be actuated.
When the lock button is in the unlocked position
switch can be actuated.
Switch action
1
► 1. Switch
CAUTION:
•
Before inserting the battery cartridge into the
tool, always check to see that the switch actu-
ates properly and returns to the "OFF" position
when released.
To start the tool, first move the lock button to the
released position
to release the switch. And then
simply push the switch on the
rotation and the
side for the counterclockwise rota-
tion Release the switch to stop.
CAUTION:
•
Always check the direction of rotation before
operation.
•
Change the direction only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the
tool.
•
When not operating the tool, always place the
lock button in the locked position .
Lighting up the front lamp
► 1. Lamp switch
, the
side for the clockwise
1
5 ENGLISH
1
► 1. Lamp
CAUTION:
•
Do not look in the light or see the source of light
directly.
To put on the light, first slide the lamp switch to
the
position and then push the
switch. Release it to stop.
NOTE:
•
When the lamp switch is in the locked posi-
tion , lamp switch cannot be actuated.
CAUTION:
•
Always slide the lamp switch to the locked posi-
tion
when not operating the tool.
NOTE:
•
Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
ASSEMBLY
CAUTION:
•
Always be sure that the lock button is in the
locked position
tridge is removed before carrying out any work
on the tool.
mark on the lamp
mark and the battery car-
Publicité
Table des Matières
