Check The Following Before Start-Up; Preparing The Pump; Fitting The Line Connections - Steinbach SPS 50-1 Notice Originale

Check the following before start-up

- The device is out of the pool and the power cable is disconnected from the mains

Preparing the pump

At the time of delivery, the pump is only partially assembled.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components. Do not use any tools.
You can use Teflon tape to seal screw connections with minor leakage.
1. Loosen the threaded ring
cover by turning it counterclockwise.
2
2. Lift the prefilter cover
ring off the pump housing.
3. Insert the large O-ring seal
groove on the pump housing.
4. Insert the prefilter
11
The prefilter is already inserted into the pump
at the factory.
5. Place the prefilter cover
housing.
6. Guide the threaded ring over the prefilter
cover.
7. Turn the threaded ring clockwise until it is
hand-tight.
8. Insert the small O-ring seal
9. Screw the hose adapter
10. Place the medium O-ring seal
11. Screw a hose adapter
The pump is ready for operation. You can now connect it to the lines.

Fitting the line connections

Some hoses, such as the pressure hose, are very stiff. Place them in the sun before use
so that the heat makes them more flexible.
Only hand-tighten all screw connections. Excessive tightening of the screw connections
damages gaskets and plastic components.
Use suitable pool hoses Ø 32 / 38 mm for the described connections. Other pool hoses (such as INTEX
with threaded connection) require additional adapters. For the matching adapters, visit our web shop at:
www.steinbach-group.com
To connect a swimming pool hose to the pump
or filter vessel, proceed as follows:
1. Guide a hose clamp over the hose.
2. Push the hose onto the hose connection.
3. Fix the hose clamp on the hose connection
using a Phillips screwdriver PH1.
The swimming pool hose is connected.
on the prefilter
1
with the threaded
2
into the
3
into the pump.
on the pump
2
into the prefilter cover.
7
clockwise into the prefilter cover until it is hand-tight.
6
into the recess of the pump outlet
5
clockwise into the pump outlet until hand-tight.
6
1
1
2
7
3
11
.
10
2
6
5
10
23