LaMotte WaterLink Spin Touch FF Manuel D'instruction page 7

TESTING
1. Press and hold until the meter turns on.
2. Tap . Select a Water type. Tap
3. Tap . Select a disk series (found on disk packaging). Tap
NOTE: Disk Series are limited by Water type selection.
4. Remove a disk from the packaging.
5. Use the syringe (1189) to fi ll the disk with the water sample.
6. Insert the disk. Cover the disk with the Universal Disk Cover (1719). Close the lid.
7. Tap to start test. Tap
disk.
8. The results will be displayed.
9. Choose an option.
¬ Tap
¬ Tap the highlighted
not enabled.
¬ Tap the hightlighted
Printer.
¬ Tap the highlighted
¬ Tap
10. Press and hold
For the most accurate results samples should be at room temperature.
The blank well allows the readings to be corrected for small amounts of color and turbidity in the
sample water. For the best results allow samples with a large amount of solids to settle before testing.
NOTE: For water samples over 100 °F (38 °C) subtract 0.3 from pH result or, for the most accurate
result, wait until water sample is below 90 °F (32 °C) to test.
Remove salt residue daily. Salt will damage the meter and cause inaccurate results. See Cleaning,
page 20.
Water type
Fresh
Disk Series
FF104
16-Apr-20
07:11 AM
to cancel the test. If the test is cancelled discard the
to add a tag.
to save the test results to the test log if Auto Save is
to send the results to the enabled Mobile Bluetooth
to send the results to a Bluetooth enabled device.
to return to the Test Screen.
for 2 seconds to turn the meter off .
Tap to
Start Test
to confi rm.
7
to confi rm.