LaMotte WaterLink Spin Touch FF Manuel D'instruction page 12

Other About... lists the Serial Number, Firmware Version, Bluetooth MAC address,
Bluetooth Version and Test Count. The Test Count shows the number of
Settings
complete tests that have been performed over the lifetime of the meter.
Tap
Ranges Enabled allows the option of having test results that are out of the
range of the reagent system displayed in red. The default setting is on.
Select Disk Detection to display an error message and abort the test when
improper testing conditions, such as No Disk, No Disk Cover, Used Disk or
Meter Check Disk, are present that would result in inaccurate or no test
results. The default setting is OFF. Tap
RANGES
Freshwater FF104 (Code 4351)
Test Factor
Alkalinity
Ammonia
Hardness
Nitrate
Nitrite
pH
Phosphate
Saltwater FF203 (Code 4352)
Test Factor
Alkalinity
Ammonia
Calcium
Magnesium
Nitrate
Nitrite
pH
Phosphate
Test results that are out of range of the reagent system wil be RED.
not be accurate. Go SETTINGS>Other Settings to turn the Ranges Enabled feature OFF.
Testing samples for Nitrate immediately after treatment with a chlorine neutralizer
containing sodium thiosulfate will give low results. Retest in 2-3 days.
If the concentration for one test factor is signifi cantly out of the range for the reagent
system, the accuracy of the results for the other test factors may be aff ected.
to return to the Settings menu.
Range
0-250 ppm
0.0-4.0 ppm
0-500 ppm
0-250 ppm
0.0-2.0 ppm
4.5-10.0
0.0 - 2.0 ppm
Range
0-350 ppm
0.0-4.0 ppm
200-800 ppm
500-2200 ppm
0-60 ppm
0.0-2.0 ppm
6.5-10.0
0.0 - 2.0 ppm
to return to the Settings menu.
Display Abbreviation
Display Abbreviation
12
ALK
AMMO
G HARD
NITRATE
NITRITE
pH
PHOS
ALK
AMMO
Ca
Mg
NITRATE
NITRITE
pH
PHOS
RED test results may