Selecting The External Component To Use - JVC KS-FX270 Manuel D'instructions

Selecting the external component to use

You can connect the external component to the CD changer jack on the rear using the Line
Input Adaptor KS-U57 (not supplied).
To use the external component as the playback source through this receiver, you need to
select which device — CD changer or external component — to use. When shipped from the
factory, CD changer is selected as the external component.
LINE IN: To use the external component other than CD changer
CHANGER: To use the CD changer
4
1
2
3
4
5
Note:
• For connecting the Line Input Adaptor KS-U57 and the external component, refer to the
Installation/connection Manual (separate volume).
2,5
Change the source to FM, AM or TAPE.
Press and hold SEL for more than 2 seconds.
"CLOCK H", "CLOCK M", "SCM LINK", "LEVEL", "B.SKIP"
or "EXT IN" appears on the display.
Select "LINE IN" if not shown on the display.
Select the desired mode — "LINE IN" or
"CHANGER".
Finish the setting
3
1
27