Technical Data; Intended Use - Leister TRIAC S Notice D'utilisation

Technical Data

Voltage [V]
Frequency [Hz]
Power [W]
Temperatur [°C]
[°F]
Air flow (20°C) [l/min]
[cfm]
Weight with cord [kg]
[lbs]
Dimensions L x Ø [mm]
Protection class
Noise level L [dB]
pA
Product Features
1. Nozzle*, slide-on type 1.1 . Nozzle*, screw-on type 2. Screw 3. Heating element for slide-on nozzles* 3.1.
Heating element for screw-on nozzles* 4. Cooled protection tube 5. Temperature scale 6. Rubber foot 7. Mains
connection 8. Mains switch 9. Air filter 10. Potentiometer for temperature adjustment 11. Digital display

Intended Use

When observing the safety instructions and using original Leister accessories, this hot air tool is suitable for all hot
air applications listed in these operating instructions.
Applications
Welding of thermoplastics as well as individual thermoplastic elastomer and elastomer bitumen in the form of
plates, pipes, and profiles, sealing layers, coated fabrics, foils, foams, tiles and layers. The following methods/
procedures are possible: Overlap, wire, band, heating element and fusion welding with Leister nozzles
Heating for forming, bending and coupling of thermoplastic components
Drying of moist surfaces
Shrinking of heat-shrinkable sleeves/hoses, solder connectors as well as packaging for electrical components
Soldering of copper tubing, solder connectors and metal foils
Defrosting frozen water lines
Activating/dissolving solvent-free and hot-melt adhesives
Igniting of wood chips, paper, coal or straw in furnaces
Mounting the Nozzle
Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle, allow the unit to cool
down completely or use a suitable tool.
A falling down nozzle can set an object on fire. Nozzles must be mounted firmly and secure on the unit.
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof surfaces.
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only original noz-
zles according to the table that are suitable for your unit.
For units with slide-on nozzle*:
Slide the nozzle 1 onto the heating-element tube 3 and tighten the screw 2.
For units with screw-on nozzle*:
Screw the nozzle 1.1 onto the heating-element tube 3.1 and tighten using an open-end spanner, size 17 mm.
* Nozzles not included in the delivery scope!
English - 9 -
TRIAC S
42 100 120
50/60
1000 1400 1600
20 – 700
70 – 1290
230
8
1,3
2,8
340 x 90, Handle Ø 56
II/ (Double insulated)
65
200 230 42
1400 1600 1000
340 x 90, Handle Ø 56
II/
TRIAC PID
100 120 200
50/60
1400 1600 1400
20 – 600
70 – 1110
230
8
1,4
3,0
(Double insulated)
65
230
1600