Cooktop Use - Whirlpool WFG530S0EW Instructions D'utilisation

KEYPAD FEATURE
KEEP WARM Hold warm
CONVECT Convection
BAKE baking and
roasting
COOK TIME Delayed start
DELAY START Timed cooking
SELF CLEAN Self-Cleaning
cycle
HOLD 3 SEC Oven control
TO LOCK lockout
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners when
control knobs are turned to IGNITE.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner using empty cookware or without
cookware on the grate.
INSTRUCTIONS
Food must be at serving temperature before placing it in the warmed oven.
1. Press KEEP WARM.
2. Temperature is set at 170°F (75°C) for 60 minutes (1 hour).
3. Press START.
4. Press CANCEL when finished.
NOTE: The oven will automatically turn off after 60 minutes.
1. Press CONVECT BAKE.
2. Press TEMP/TIME "up" or "down" arrows to set a temperature other than 350°F (175°C) in 5°
increments between 170°F and 525°F (75°C and 275°C).
3. Press START.
4. To change the temperature, repeat Step 2. Press START or wait 5 seconds for the change to
take effect.
5. Press CANCEL when finished.
NOTE: There is a 5-minute delay before the convection fan turns on when starting a Convect Bake
Cycle.
The Cook Time keypad is used to enter the starting time for an oven function with a delayed start.
Cook Time should not be used for foods such as breads and cakes because they may not bake
properly.
To set a Timed Cook or a Delayed Timed Cook, see "Cook Time" section.
Delay Start allows the oven to be set to turn on at a certain time of day, cook for a set length of
time, and/or shut off automatically. Delay start should not be used for foods such as breads and
cakes because they may not bake properly.
To set a Timed Cook or a Delayed Timed Cook, see "Cook Time" section.
See the "Self-Cleaning Cycle" section.
No keypads will function with the controls locked.
1. Check that the oven and the Timer are off.
2. Press and hold START for 3 seconds.
3. If enabled, a tone will sound, and "CONTROL LOCKED" will be displayed.
4. Repeat to unlock.

COOKTOP USE

To Set:
1. Push in and turn knob counterclockwise to IGNITE.
All surface burners will click. Only the burner with the control
knob turned to IGNITE will produce a flame.
2. Turn knob to anywhere between HIGH and LOW.
REMEMBER: When range is in use, the entire cooktop area
may become hot.
Power Failure
In case of prolonged power failure, the surface burners can be lit
manually. Hold a lit match near a burner and turn knob
counterclockwise to IGNITE. After burner lights, turn knob to
setting.
5