Optional Accessories - Makita XRM05 Manuel D'instructions

Press the switch as shown below to change modes.
Main LED (20 pcs.) light up
Main LED (10 pcs.) light up*
Sub LED (1 pc.) light up
OFF
* The LEDs of the two rows on the opposite side of the
switch light up.
Metal hook (Fig. 3)
Pivot the metal hook upright before using it.
The hook can be turned at 360° and removed.
Connecting USB devices (Fig. 4)
CAUTION:
• Connect only devices which are compatible with the
USB power supply port. Otherwise it may cause
malfunction to the battery holder.
This luminaire (with the battery) can work as an external
power supply for USB devices.
Open the cover and connect the USB cable (not included)
with the power supply port of the battery holder. And then
connect the other end of the cable with the device.
The USB power supply port (with the battery) supplies
DC5V, 2.1A.
NOTE:
• Before connecting USB device to the luminaire (with
the battery), always backup your data of USB device.
Otherwise your data may be lost by any possibility.
• The luminaire may not supply power to some USB
devices.
• Wait for 10 seconds before charging another device
consecutively.
• When not using or after charging, remove the USB
cable and close the cover.
MAINTENANCE
To maintain product safety and reliability, repairs and
maintenance should be carried out by a Makita Authorized
Service Center.
CAUTION:
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended for
use with your Makita luminaire specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. The accessories or
attachments should be used only in the proper and
intended manner.
• Shoulder strap
• Makita genuine battery and charger
NOTE:
• Some items in the list may be included in the luminaire
package as standard accessories. They may differ from
country to country.
5