Connection Diagram; Rear Panel Overview - Alesis QX49 Guide D'utilisation Rapide

BOX CONTENTS
•
QX49
•
USB cable
•
Software DVD
•
Quickstart Guide
•
Safety Instructions & Warranty Information Booklet

CONNECTION DIAGRAM

Please refer to the following scenario for connecting
the QX49.
1. Connect a USB cable from your computer to the
QX49. The unit will be powered through the
USB connection.
QX49 to your computer, it will automatically
install the necessary drivers. (If you use a PC, a
dialog box will appear telling you the "new
hardware" is ready to use.)
Alternatively, if you do not wish to use a
computer in your setup or if you wish to power
the QX49 externally, please plug in a 9V DC,
500mA power adapter, center-positive, 5.5mm
barrel diameter.
2. If you would like to use an external sound
module, connect a 5-pin MIDI cable from the
KEYBOARD MIDI OUT of the QX49 to the MIDI
IN of the external device.

REAR PANEL OVERVIEW

1. DC POWER ADAPTER INPUT – Plug in
a 9V DC, 500mA power adapter, center-
positive, 5.5mm barrel diameter (sold
separately) if you do not wish to power
the QX49 through the USB connection.
2. POWER SWITCH – Turns the power
on/off. If you are using a power adapter
(sold separately), set the switch to
"POWER" when turning it on. If you are powering it via its USB CONNECTION, set the switch to "USB"
when turning it on.
3. USB PORT – Plug a standard USB cable into this outlet and into the USB port of your computer. The
computer's USB port will provide power to the QX49. This connection is used to send and receive MIDI
data to and from your computer and may also be used to send MIDI data from your computer to a
device attached to the MIDI OUT port of the QX49.
4. KEYBOARD MIDI OUT – Use a five-pin MIDI cable (sold separately) to connect this jack to the MIDI IN
of an external device.
5. COMPUTER MIDI OUT – Use a five-pin MIDI cable (sold separately) to connect this jack to the MIDI IN
of an external sound module. An external sound module connected to this output can be controlled by
your computer (connected to the USB PORT).
6. SUSTAIN PEDAL INPUT – Connect a 1/4" TS sustain pedal (sold separately) to this input.
The first time you connect
COMPUTER
(not included)
SUSTAIN PEDAL
(not included)
EXTERNAL SOUND MODULE
5 4
6
2
POWER ADAPTER
(not included)
(not included)
2
3
1