Thermostat Mounting - Honeywell CT87N Easy-To-See Mode D'emploi

CT87N Easy-To-See
Fan operation settings
Move the switch to the proper setting for
your system:
F: For gas or oil heating systems, leave
the fan operation switch in this factory-
set position (for systems that control the
fan in a call for heat).
E: Change the switch to this setting for
heat pump or electric heat systems.
(This setting is for systems that allow
the thermostat to control the fan in a
call for heat, if a fan wire is connected to
the G terminal.)
Cycle rate settings

Thermostat mounting

Thermostat
69-1919EFS—06
• Owner's Manual
TM
Coverplate
and subbase
Heating System
Steam or gravity
High efficiency warm air
(90% plus efficiency),
hot water, or heat pump
Gas or oil warm air
(factory setting)
Electric warm air
1. Align the slots on the base with tabs on the
thermostat, then push gently until the
thermostat snaps into place.
2. Restore electrical power at the heating/cooling
system, or at the fuse/circuit-breaker panel.
4
E
F
Move the cycle rate switches
to the proper setting for your
system (see table below).
Switch 1
On
Off
Off
On
Switch 2
On
On
Off
Off