Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION OF THE DEVICE
Features
UV Spot as LED DMX model
• DMX-512 control via regular DMX-controller (occupies 2 channels)
• Equipped with 183 x 10 mm UV LEDs
• Locking possibility at the mounting bracket
• For illuminating e. g. mirror balls, entrance or counter areas or as basic illumination
• Perfect for halls, discotheques, stages and clubs
• Advantages of LED-technology: extremely long life of the LEDs, low power consumption, minimal heat
emission, defacto maintenance free with brilliant light radiation
• Available in alu or in black
INSTALLATION
Overhead rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.
16/39
51913700_V_1_0.DOC
Publicité
Table des Matières
