Wesco W-TPY38 Mode D'emploi Et D'installation page 33

Caution!
• This appliance can only be connected to a network 230 V~ 50/60 Hz.
• You should always connect the earth wire.
• Respect the connection diagram.
Use the connecting cable that is attached to the device.
The green / yellow wire corresponds to the earth wire, the blue wire corresponds to the neutral
one and the brown wire corresponds to the phase.
Mains
230V~ 50/60Hz
* calculated with the simultaneous factor following the standard EN 60 335-2-6
Caution! Be careful to correctly engage and tighten the cables.
We cannot be held responsible for any incident resulting from incorrect connection or
which could arise from the use of an appliance which has not been earthed or has been
Connection Cable diameter
1 Phase + N 3 x 2,5 mm²
equipped with a faulty earth connection.
Cable
H 05 VV - F
H 05 RR - F
33
Protection calibre
16 A *