What To Do In Case Of A Problem - Wesco W-TPY38 Mode D'emploi Et D'installation

WHAT TO DO IN CASE OF A PROBLEM

The hob or the cooking zone does not start:
• The hob is badly connected to the electrical network.
• The safety fuse is cut off.
• The lock function is activated.
• The sensitive touch keys are covered with grease or water.
• An object is put on a sensitive touch key.
The control panel displays [ E ]:
• Disconnect and reconnect the hob.
• Call after sales service.
One or all cooking zone(s) cut off:
• The safety system functioned.
• This system works when you forgot to switch off the cooking zone.
• One or more sensitive touch keys are covered.
• The pan is empty and its bottom overheated.
• The hob also has an automatic reduction of Booster level and breaking Automatic
overheating
The ventilation system is still working after switching the hob off:
• This is not a failure, the fan continues to protect the electronic device.
• The fan stops automatically.
The automatic cooking system does not start:
• The cooking zone is still hot [ H ].
• The highest Booster level is set [ 9 ].
The control panel displays [ II ]:
• See chapter "Stop&Go".
The control panel displays [ ] or [ Er03 ] :
• n object or liquid covers the control keys. The symbol disappear as soon as the key is
released or cleaned.
The control panel displays [ E2 ] :
• The hob is overheated, let it cool and then turn it on again.
The control panel displays [ E8 ] :
• The air inlet of the ventilator is obstructed, release it.
The control panel displays [ U400 ] :
• The hob is not connected to the network. Check the connection and reconnect the
hob.
The control panel displays [ Er47 ] :
• The hob is not connected to the network. Check the connection and reconnect the
hob.
30