Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELPMBPRH
Projector Mount Installation
1.
Carefully determine required mounting location.
IMPORTANT ! : This will require knowing the lens to
screen distance. See projector specifications for details
on determining this distance.
2.
Install 1-1/2" NPT or NPSM following ANSI/ASME B1.20.1
(Schedule 40, 0.154" minimum thickness steel or aluminum
- ASTM B221) threaded extension column (not included)
into threaded collar (not included) until tight, with a minimum
of four threads engaged. (See Figure 1)
WARNING:
IMPROPER INSTALLATION CAN RESULT IN
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Structural members MUST be capable of
supporting five times the combined weight of all equipment
being mounted.
3.
Align projector mount (C) with end of NPT pipe.
4.
Thread projector mount up onto pipe by turning until hand
tight. (See Figure 1)
(not included)
4
Figure 1
Rough Alignment of Projector Mount
5.
Turn projector mount (C) clockwise or counter-clockwise
until front of mount is facing target.
6.
Secure projector mount to pipe by turning set screw
(shipped installed in projector mount) until tight.
CAUTION:
DO NOT OVERTIGHTEN! Overtightening of set
screw can damage threads on pipe.
6
(not included)
2
3
(C)
7.
Turn security screw (shipped installed in projector mount
and accessed through bottom of projector mount) using a
Phillips screwdriver until set screw cannot be seen through
access hole in projector mount. (See Figure 2)
5
(C)
(access hole - security screw)
5
Figure 2
Installation Instructions
(access hole - set screw)
6
(bottom view)
7
Publicité
Table des Matières
