Installation Instructions; Before You Begin; Beverage Center; Location Requirements - Cafe CCP06BP Serie Manuel D'utilisation Et D'installation

Installation
Instructions
Questions? Visit our Website at: cafeappliances.com
In Canada, visit cafeappliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.
IMPORTANT
•
and ordinances. Save these instructions for local
inspector's use.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer –
future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Beverage center Installation
can vary
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
WARNING
EXCESS WEIGHT HAZARD
Use two or more people to move and install

beverage center.

Failure to do so can result in back or other injury.
IMPORTANT: Handle with care when moving beverage
center to avoid either damaging the refrigerant tubing or
increasing the risk of a leak.
IMPORTANT: If the beverage center has been placed in
before plugging in to allow the refrigerant to settle.
10
—
Observe all governing codes
Beverage Center

LOCATION REQUIREMENTS

IMPORTANT: Before use, this beverage center must
be installed properly.
NOTE: Allow the beverage center to sit upright on its
base for at least one hour before installation.
• Do not install the beverage center where the
temperature will go below 55°F (13°C) because
it will not run often enough to maintain proper
temperatures.
• Do not install the beverage center where the
temperature will go above 110°F (43°C) because it
will not perform properly.
• Install it on a floor strong enough to support it fully
loaded.
• Do not install the beverage center in a location
exposed to water (rain, etc.) or direct sunlight.
TOOLS NEEDED
• Phillips Screwdriver
• Measuring Tape
• Carpenter's Level
PARTS SUPPLIED
Anti-tip Brackets (Qty 4)
Protective Guard (Qty 1)
Handle (Qty 1)
Screws
Screw A Screw B Screw C
- Qty 4 - Qty 6
Screw D Screw E
- Qty 4 - Qty 4 - Qty 2
49-1000491 Rev. 3