Sartorius Entris Mode D'emploi page 8

8
Installation
Setting up the Balance
Balances with Sliding Panel Draft Shield
Place the components listed below inside the
t
weighing chamber in the order given:
– Shield plate
– Shield disk
– Pan support
– Weighing pan
Balances with Round Glass Draft Shield
Position the components listed below in the order
t
given:
– Place lid on top of the balance with the rim facing
upwards and rotate until it is securely in place
– Pan support
– Weighing pan
– Glass cover
– Cover with the rim facing downwards
Balances with a Round Weighing Pan
Position the components listed below in the order
t
given:
– Pan support
– Weighing pan
Balances with a Rectangular Weighing Pan
Place the weighing pan on the balance
t