Getting Started - Sartorius Entris Mode D'emploi

Getting Started

Storage and Shipping Conditions
– Do not expose the balance to extreme
temperatures, moisture, shocks, blows,
or vibration.
Unpacking the Equipment
After unpacking the device, check it
t
immediately for any external damage.
y If you detect any damage, proceed as
directed on the CD-ROM in the "Care
and Maintenance" chapter, "Safety
Inspection" section.
y Save all parts of the original packaging
for any future transportation. During
shipment, please do not leave cables
plugged in!
Equipment Supplied
– Balance
– Weighing pan
– Pan support only for models with
a round weighing pan
– Mains power supply unit
Additional equipment on the following
models:
Entris64-1S, Entris124-1S,
Entris224-1S, Entris64i-1S,
Entris124i-1S, Entris224i-1S
– Sliding panel draft shield
– Shield disk
– Shield plate
– Dust cover
Additional equipment on the following
models:
Entris153-1S, Entris323-1S,
Entris423-1S, Entris623-1S,
Entris153i-1S, Entris323i-1S,
Entris423i-1S, Entris623i-1S
– Round glass draft shield
(with shield plate and cover)
Setup
Choose a location that is not subject
to the following negative influences:
– Heat (heater or direct sunlight)
– Drafts from open windows and doors
– Extreme vibrations during weighing
– Extreme humidity
Conditioning the Balance
Moisture in the air can condense on
cold surfaces whenever the equipment is
moved to a substantially warmer place.
Allow the device to acclimatize for
about 2 hours at room temperature,
leaving it unplugged from the power
supply.
7