Applications - IMG STAGELINE LE-500C Mode D'emploi

For cleaning only use a dry, soft cloth; never use
GB
chemicals or water.
No liability for any damage will be accepted if the
controller or the power supply unit is used for other
purposes than originally intended, if it is not correctly
connected or operated or not repaired in an expert
way.
If the controller or the power supply unit are to be put
out of operation definitively, take them to a local recy-
cling plant for a disposal which is not harmful to the
environment.

3 Applications

The miniature DMX controllers are specially designed
for controlling the following light effect units from the
"img Stage Line" range:
Controller
LE-500C
LE-510C
LE-550C
The units offer
be switched automatically, manually or via the built-in
microphone. The miniature controllers are respectively
matched to the corresponding light effect unit. Via the
programmes, the X-direction and Y-direction of the mir-
10
Light effect unit
LE-500DMX
LE-510DMX
LE-550DMX
various fixed programmes
rors, the various gobos, and the iris are controlled.
Thus, various multicoloured geometric patterns can be
projected providing an ideal dance floor atmosphere.
4 Operation
4.1 Adjustments on the light effect units
Each light effect unit to be connected to a controller
must be provided with a starting address first. For this
purpose, disconnect the light effect units from the
power supply, i. e. disconnect the mains plugs from the
sockets. With the DIP switches at the front or upper
side of the light effect units, binary adjustment of the
starting address is made as follows (also see
the operating instructions of the light effect unit):
LE-500DMX and LE-510DMX (4 channels each)
Channels 1 to 4
LE-550DMX (5 channels)
O N
to
1 2 3 4 5 6 7 8
Dipswitch A
Channels 1 to 3 and channels 4 to 5
or
or channels 5 to 8
O N
1 2 3 4 5 6 7 8
Dipswitch B
etc.