IMG STAGELINE LE-500C Mode D'emploi page 13

LE-550C
1) Use the button TRIG/AUDIO (7) to start the auto-
matic programme sequence (see chapter 5.2, if re-
quired). The display shows "tr".
2) Press the button TRIG/AUDIO twice in succession.
The time difference between the first and the second
actuation of the button defines the trigger time and
thus the programme speed. As a check of the trigger
time, a point will flash on the display.
5.6 Adjusting the stroboscopic effect
With the button STROB (2), the stroboscopic effect can
be switched on or off independent of the selected pro-
gramme mode and the selected programme number.
The display shows "St" (strobe).
For the stroboscopic effect, the light effect unit will
select the white circle on the pattern disk and an iris will
open and close in rapid succession. The mirror control
is independent of this selection.
5.7 Blackout
A so-called blackout available by actuating the red but-
ton B/O (6) provides immediate rest periods of the light
effect unit. The display shows "bo". An iris in the light ef-
fect unit is closed and the mirror movements are
stopped. The programme is continued upon repeated
actuation of the button B/O.
6 Specifications
Power supply: . . . . . . . . . 9 V /100 mA via supplied
Display: . . . . . . . . . . . . . . 2-digit 7-segment
Dimensions: . . . . . . . . . . 70 x 35 x 115 mm
Weight: . . . . . . . . . . . . . . 250 g
Connections
DMX output: . . . . . . . . 1 x XLR jack
Power supply: . . . . . . . 1 x low voltage jack
According to the manufacturer.
Subject to technical change.
power supply unit connect-
ed to 230 V~/50 Hz/5 VA
display
5.5/2.1 mm
GB
13