Position And Function Of The Control Buttons And Connections - Berger 359830 Manuel D'utilisation

GB

2. POSITION AND FUNCTION OF THE CONTROL BUTTONS AND CONNECTIONS

1
2
3
4
5
Position Tastenbeschriftung Funktion
1 Input / MENU • Input signal selection: Satellite, DTV
(antenna, cable), ATV (analog RF), AV, PC,
SCART, Component (YpbPr), DVD, HDMI1,
HDMI2 and Media (via USB).
CH+/- • Program Channel Selection. Press this but-
2
ton to select the channels or to select the
upper or lower menu in the OSD menu.
3 VOL+/- • Increase or decrease the volume
• Adjusting the selected menu items in the
OSD menu
4 DVD Play, Eject • Start DVD
• Eject DVD
• Power button: Switches the TV on or off
5
in standby mode
front bottom right Remote control • Infrared receiver for remote control
sensor
Power indicator • Lights red: Standby
front bottom right
• Lights up green: TV is on
• Not lit: TV is completely without power
right side back Main switch • Disconnecting the TV from the power
The on/off switch is located at the back next to the control buttons.
Note/reminder:
If the TV does not receive an HDMI signal after one minute, or does not receive a video
signal for 15 minutes, the TV will automatically switch to standby. The power indicator
LED will then light up red.
36
Rear view (connection strip at the bottom)
1 2 3 4
1 Power input DC 12/24V 5 HDMI1 input
2 Lan connection 6 HDMI2 input
3 Analogue video output 7 RF S2: SAT antenna input
4 Analogue sound output 8 RF T2: Cable connection/Terr. antenna input
Side view
1 2 4 3
1 Digital sound output
2 AV input (via adapter cable)
3 Headphone socket (analogue sound output)
4 Via 2 and 3: CI+ slot for decoding modules
5 2 x USB connection; together up to max. 500 mA, e.g. for hard disks, sound bars or
similar.
AV-cable
Plugs into socket 2 (AV input) on the rear of the TV, if required.
Yellow = Video
Red = Right sound channel
White = Left sound channel
GB
5 6 7 8
5
37