Panasonic EH-XR10 Mode D'emploi page 16

Notes
• The appliance can be used on the skin even while
indicators are fl ashing. The lamps will begin glowing
once contact is made with the skin.
• An alert tone will be triggered 15 seconds after the
appliance is not in contact with the skin. Then, the power
will automatically turn off after approximately 1 minute.
Changing the level after the preheating process
completes
The level changes with each pressing of the
LOW
• Select an appropriate level while paying attention to
the condition of skin.
5
5
Once the preheating process completes,
press the appliance onto your skin and
begin moving it around. (See page 17.)
The power will be automatically turned off after each
mode is completed.
• Press the POWER/SELECT switch to change the
mode or turn off the power midway through.
16
EH-XR10_EU.indb 16
.
MED HIGH
How to apply the head properly
• Apply the appliance to the skin as
both ultrasonic probe (a) and frame
(b) are making complete contact.
• Press the appliance tightly to the skin
as both ultrasonic probe and frame
are contacting the skin in parallel.
The head vibrates except in RF mode.
• RF and Ultrasonic are only effective when the
head is vibrating.
Note
• Head vibration produces sound, which is just normal operation.
Situations of an alert sound triggering followed by
vibration stopping
Remove and press the ultrasonic probe on your skin
again if either of the following notifi cations occur.
► Over-care prevention sensor
The ultrasonic probe has been in contact with your face
for approximately 15 seconds.
►Fitted contact sensor
The ultrasonic probe has not made contact with the skin
for approximately 15 seconds.
An alert will trigger and the power will turn off after
approximately 1 minute if the appliance continues in
either of these states.


2019/03/14 19:45:09