Elma COOKER CLIP Manuel D'utilisation page 13

03. MAINTENANCE AND WARNINGS.
CLEANING
Exterior part
Clean the exterior part of the device with a damp cloth, using a neutral soap, and then drying it.
Interior part
1. Place the machine on the container. Pour water into the container up to the "MAX" line of the
device. Use a proportion of 5g of vinegar with 10 litres of water. Add the vinegar to the water based
on the volume of the container
2. Turn on the machine, set the temperature to 80°C (176°F), the time to 3 hours (03:00), and press
"Start". After 3 hours, the device will emit a beep, after which you can turn off the device and unplug
it from the power supply.
3. Check whether the device is sufficiently clean. If not, add the vinegar to the container again and
carry out step 2. If the device is sufficiently clean, rinse it with clean water, dry it and then store it.
Note: We recommend thoroughly cleaning the device after every 20 uses or 100 hours of use.
Problem
The device does not work 1. The power cable is not correctly plugged in.
The water temperature 1. The temperature is set under or near to the
does not rise
The water heats up after
the temperature set has
been reached
E01 2. The device has come out of the water while
appears on the screen
Loud noise from the pump
Cause
2. Problem with the power supply.
water temperature.
2. The heating time is too short.
1. The programme is incorrect.
2. The temperature sensor is not working.
3. The circulator does not turn.
1. The water level is too low or too high.
operating.
1 Air inside the pump.
2. Dirt inside the pump.
Solution
1. Plug in and turn on the device.
2. Check whether other machines operate normally.
1. Check the setting.
2. Increase the heating time.
1. Check the programme and reset the power switch.
2. Contact technical support.
3. Contact technical support.
1. Add water, ensure that the water level is between the
"MIN" and "MAX" lines.
2. Place the device in the water and reset the power
switch.
1. Accumulation of air, let it operate. It will dissipate by
itself.
2. Clean the device and the pump, following the steps
established in the instruction manual
(or contact technical support).
13