Detaching the Worktop
After the worktop has been removed the appliance can be installed
underneath a continuous worktop. The procedure is as follows:
1.Unscrew the screws (1) on the
right and the left.
2. Lift the worktop slightly, push
it about 20 mm towards the
rear, and lift it off upwards (2).
To remove the top of the
refrigerator
screws on the front-right- and
front-left-hand side (3) and
keep it in a safe place (4).
Levelling
The appliance must be level. Level the
appliance by adjusting the two adjustable feet
(1) at the front of the appliance.
If required the washer (2) can be removed.
Reversing the Door
The side at which the door opens can be changed from the right side (as
supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
beforehand.
Carefully tilt the appliance to the back and place an adequate object under
it.
Take care to avoid the compressor or the condenser touching the ground.
Unscrew both adjustable legs at the front.
28
unfasten
the
2
1