Atag VA8015NT Mode D'emploi page 73

Problem
The dishwasher does not start.
The dishes are not clean.
Spots on stainless steel or silver.
Possible causes
The Start/Stop start button has been pressed for
too short a time.
The door is not properly closed.
You have opened the dishwasher to add more
dishes while a programme is in progress.
The door lock has not clicked into place and
locked.
A fuse/circuit breaker has been tripped.
The plug is not plugged into the wall socket.
The water tap is turned off.
Overflow/leaks.
A whirring sound (the drainage pump) is heard
from the dishwasher and does not stop when the
main power switch is turned off.
Check that the Delayed Start option has not been
selected.
The spray arms do not rotate.
Spray arm holes or bearings blocked.
Unsuitable dishwashing programme.
Incorrect detergent dosage.
Old detergent. Detergent is a perishable product.
Dishes loaded incorrectly.
Glasses and cups have toppled over during the
programme.
The filters are not fitted correctly.
Drainage pump stop missing.
Some foodstuffs, such as mustard, mayonnaise,
lemon, vinegar, salt and dressings, can mark
stainless steel if left for too long.
All stainless steel can cause spots on silver if
they come into contact during dishwashing.
Aluminium can also cause spots on dishes.
Action
Press and hold Start/Stop until the display shows
"Program started".
Check.
Close the door and wait. After a while, the
dishwasher continues the programme.
Check the door lock. If it has not clicked into
place and locked, open the door.
Press and hold the navigation button
the option button Auto Open
Then wait 30 seconds. Close the door. Check
that the door lock clicks into place and locks and
that the dishwasher starts.
Check.
Check.
Check.
Check.
Turn off the water tap. Pull out the plug and call
the service department.
Press and hold Start/Stop for three seconds if
you want to cancel the Delayed Start option.
Check that the dishes are not blocking the spray
arms.
Clean the spray arms. See the chapter Care and
cleaning.
Choose a longer programme.
Dose according to water hardness. Far too much
or far too little detergent results in poorer
dishwashing results.
Avoid large packages.
Do not cover porcelain with large bowls or the
like. Avoid placing very tall glasses in the corners
of the baskets.
Place dishes to sit steady.
Check that the filter handle is locked in the stop
position. The handle should point straight out
from the dishwasher.
Check that the coloured stop on the right in the
bottom drain is in place. See the chapter Care
and cleaning.
Rinse off these types of foodstuffs if not starting
the dishwasher immediately. Use the Rinse &
hold programme.
In order to avoid marks and tarnishing, separate
dishes made from different metals, such as silver,
stainless steel and aluminium.
and
for five seconds.
17