GLOBBER ONE K E-MOTION 15 Mode D'emploi page 6

CHECK SPEED
To control the speed, you can simultaneously OR independently use the brake located at
the rear of the scooter (mudguard) or/and use the acceleration sensor located on the top of
the deck.
(Press with your foot to accelerate, remove your foot to slowdown)
- Once the electric motor is engaged, it will accelerate until reaching the cruising speed of
20 km/h.
- The rear brake generates both mechanical and electrical braking that reduce the braking
distance.
- WARNING! Engaging the brake (mudguard) automatically interrupts the motor when the
brake is pressed for less than 3 seconds. If you release the brake, the motor automatically
engages again.
STOP
To stop the motor completely, press the brake continuously for 3 seconds and wait for
the scooter to stop safely to get off the platform. The lights at the rear brake will also light
up when engaging. At any time you can remove your foot from the acceleration sensor
to automatically shut down the motor for example in an emergency. The battery will
automatically turn itself off when the motor is not engaged for more than 60 seconds.
5 - CHARGING
When the battery signal light on the deck becomes low, you can
recharge the battery with the specific charger.
Your electric scooter is delivered with a specific charger.
1. To charge your electric scooter, remove the waterproof cap from the port and plug in the
charger. For safety reasons, ensure the charging port is always dry before starting to
charge.
2. Plug the charger into a suitable power source.
3. When LED on the charger is red, the battery is charging.
4. When the signal light changes to green, the LED battery is fully charged; this will take
approximately 3 hours. You must stop charging the LED light when the signal light turns
green; charging the battery for too long will reduce its lifetime.
6
1 2
The protective cover is used to protect the charging port from splashing water. Be sure to
replace the cap after each charging and before each use.
- Children shall not play the appliance.
- Cleaning and user maintenance should not be made by children without
supervision.
- The charger is specific for lithium battery pack 36V and 2.6AH
(Model No.: 10S1PSCOOTERM26).
- The battery charger has LED indicator: GREEN light indicates the battery is fully
charged or disconnected; RED light indicates the battery is in charging.
- Do not recharge non-rechargeable batteries. It may cause explosion.
- Only use the charger supplied with your electric scooter. Using a charger other than that
supplied will invalidate the warranty.
- To optimise the performances and lifetime of your electric scooter battery, fully charge the
battery before using it for the first time and fully charge it once a month.
- Do not cover the battery compartment or the charger. There must be good ventilation
conditions at all times during charging.
- The charging environment must be clean. Ensure there are no traces of damp or water in
the electric socket before plugging in.
- Ensure you use a standard socket.
- External LED light: The signal light will turn red when the LED battery has less than 10%
battery remaining. Please use the USB cable provided in-pack to charge the LED light.
When the signal light changes to green, the LED battery is fully charged; this will take
approximately 3 hours. You must stop charging the LED light when the signal light turns
green; charging the battery for too long will reduce its lifetime.
Warning. Do not use the battery or the device in the following cases:
1. The battery gives off a smell or the temperature inside the appliance is too high.
2. Leaks on the deck of the scooter.
If in doubt please contact Globber, contact@globber.com
3 4