Philips Fidelio Manuel D'utilisation page 15

Step 1: calibrate the listening
zone
1
Place the portable left and right speakers
on two seating positions you prefer most
VXFK DV RQ D VRID 
• Make sure that the portable left and
right speakers are wirelessly connected
to the main unit (press SURROUND
ON DEMAND RQ WKH VSHDNHU 
2
Press and hold CALIBRATION on the
remote control for three seconds to
trigger calibration.
» ZONE ]RQH LV GLVSOD\HG RQ WKH
display panel.
» You can hear the calibration tones
from the portable speakers.
3
Wait until the calibration tones end.
» ->SPKR VSHDNHU LV GLVSOD\HG RQ WKH
display panel.
4
Then perform the following Step 2
FDOLEUDWH WKH VXUURXQG VSHDNHU SRVLWLRQ
to complete and store the new settings.
Step 2: calibrate the surround
speaker position
1
Place the portable left and right speakers
VXUURXQG RQ WKH SRVLWLRQ \RX SUHIHU
• Make sure that the portable left and
right speakers are wirelessly connected
B5_37_UM_V1.0.indb 13
to the main unit (press SURROUND
ON DEMAND RQ WKH VSHDNHU 
2
Press CALIBRATION once to trigger
calibration.
• Press CALIBRATIONthree times to
trigger calibration if you re-locate the
portable left and right speakers and
skip Step 1 (calibrate the listening
]RQH DIWHU \RX FRPSOHWHG D URXQG RI
spatial calibration previously.
» You can hear the calibration tones
from the portable speakers.
3
Wait until the calibration tones end.
» If the calibration succeeds, DONE
GRQH LV GLVSOD\HG RQ WKH GLVSOD\
panel. And the new settings are stored.
Note
•
Spatial calibration takes around three minutes.
•
Surround sound improvement is only noticeable if
WKH SRUWDEOH OHIW DQG ULJKW VSHDNHUV VXUURXQG ZHUH
improperly placed, or if there is strong surround effect
in the music you play.
•
If the portable left and right speakers are swapped in
placement, during calibration L<->R is displayed for few
seconds, then the calibration completes.
•
During calibration, you may press CALIBRATION
to cancel calibration, and the settings returns to the
default.
•
If the spatial calibration fails, an error message is
displayed on the display panel, such as FAIL IDLO  DQG
the settings returns to the default.
•
If the spatial calibration fails, try the spatial calibration
again, and make sure that the calibration points
described at the beginning of this chapter are fully met.
EN 13
7/31/2015 5:22:55 PM