Defrosting The Freezer Compartment; Troubleshooting - Inventum IVR1021S Mode D'emploi

DEFROSTING THE FREEZER COMPARTMENT

Defrost the freezer compartment when the layer of ice reaches a thickness of 3 to 5 mm. Keep the contents of the freezer in
a cool place and wrapped in blankets or newspapers. Switch the thermostat off to "�" and unplug the appliance. Defrost the
freezer compartment.
You can speed up the defrosting process by placing a bowl
of hot water in the freezer.
1. Remove the bottom drawer and place it on the floor
aligning it to the front of the freezer.
2. Pull the drain pipe from the back of the wall inside the
freezer compartment and place it in the groove on the
front side of the floor of the aplliance.
Remove water which not flows into the drawer with a
sponge. Clean the interior of the appliance. Use warm water
and a neutral detergent to prevent any bad smells occurring.
After cleaning, rinse the interior with clean water and rub
dry. Leave the appliance to dry for 1 to 2 hours.
Switch the thermostat on to the right setting. When the freezer compartment reaches its correct temperature, replace the
food items.
Warning: Never remove the ice with the aid of sharp objects, defrost sprays, a hair-drier, a heater, or similar items. This may
lead to unsafe situations and may cause irreparable damage to the appliance.
TIPS
• High ambient temperatures have a negative effect on energy use. Keep the refrigerator in a position away from direct
sunlight or other sources of heat.
• Keep ventilation openings free. Clogged openings lead to higher use of energy.
• Try not to open the door too often, especially when the weather is wet and hot. Once you open the door, mind to close it
as soon as possible.
• Turn the thermostat to a lower setting when the circumstances allow it.
• Before storing fresh cooked food, make sure the food has cooled at least to room temperature.
• Ice and frost layer increase energy consumption, so clean the appliance as soon as the layer is 3 to 5 mm thick.
• If the gasket is damaged or if it turns out that the sealing is poor, the energy consumption is substantially higher. To
restore efficiency, replace the gasket.
• Keep the condensor on the rear wall always clean, free of dust or any impurities.
• Always consider the instructions, otherwise the energyconsumption is substantially higher.
7

troubleshooting

If your freezer does not work properly, this can be caused by a minor problem. First check the following items before
contacting an electrician. This will save you time and money.
Problem
Appliance does not do
anything
Temperature in the
freezer is too high or
too low
Appliance makes noise
The ALARM indicator
light lights up.
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
28
• English
Cause
- Plug not in socket
- Power interruption
- Thermostat is set to [OFF]
Incorrect thermostat setting
Ventilation holes are blocked
Is the appliance properly installed?
Does the rear of the freezer make
contact with something?
The plug is inserted in the socket
for the first time or there has been
a power interruption of at least one
hour.
A component is defective or there is
a breakdown in the cooling process.
Solution
- Insert the plug in the socket
- Check the fuse box
- Set the thermostat to setting 1 to 5
Set the thermostat to the correct setting
Clean the ventilation holes
Check the installation - is the freezer level?
Check this and move the freezer forward
Check that the door of the appliance is properly
closed and check that the appliance has been on for
more than one hour. If this is not the case, contact
customer service.
Contact customer service.
1
2