Fitting The Feeder; Fitting The Bushing Into The Telescopic Section; Fixing The Telescopic Section In The Drum - Wichard Facnor LS 60 Notice De Montage

4.6- FITTING THE FEEDER

bottom
LS/RX/RS RANGE

4.7- FITTING THE BUSHING INTO THE TELESCOPIC SECTION

top
Give the
bushing a
quarter turn
Assemble one bushing beneath the telescopic section, the male side pointing up. Fit the
bushing to the telescopic section and give it a quarter turn.
The bushing is fixed in place at the bottom of the telescopic section (fig. L).

4.8- FIXING THE TELESCOPIC SECTION IN THE DRUM

top
N
K
4.8.1- Slip the drum around the forestay. Loosen the screw (fig. P) slightly but sufficiently so
that the telescopic section can slide inside the nose of the drum. Lower the telescopic section
(fig. N), with its bushing (fig. O), until the bushing fits in snugly.
4.8.2- Tighten the locking screw (fig. P), which will join the drum to the telescopic section.
This screw is greased at the factory. However, it is recommended to grease it every year.
F a c n o r - I n s t a l l a t i o n m a n u a l r e v 2 0 1 6 – L S / L X / R X r e e f i n g a n d f u r l i n g s y s t e m s
top Ring
M
LX RANGE
O
L
P
M
4.8.1
First fit the sail feeder (fig. M) to the telescopic
section as indicated.
For LX models, before slipping the feeder, slip
the ring. It is not necessary to fix the stainless
steel part at this stage (see 4.11).
Fix the feeder to the telescopic section with the
screw provided, tighten until fixed (see 4.11).
L
P
M
4.8.2
English
25