Nuna tres Mode D'emploi page 14

4
- Lift the upper flap upward and pull the lower flap forward, and then store
the shoulder straps in their storage compartments. (22)-2
5
- Pull the buckle to the back of the seat pad, and then store the buckle and
buckle tongues in respective storage compartments. (22)-3 (22)-4
6
- Reattach the snaps to recover the seat pad. The recovered seat pad is
shown as (23).
For installation with ISO Connector™
1
- Insert ISO Connector™ attachment guides to assist with installation. The
ISO Connector™ attachment guides can protect the surface of the vehicle
seat from being torn. (24)
2
- Extend the ISO Connector™ attachments by pressing the adjustment
button (25) and pulling out the attachments. (26)
Make sure that both ISO Connector™ attachments are securely attached
to their ISOFIX anchor points. The colors of the indicators on both ISO
Connector™ attachments should be completely green. (27)
The ISO Connector™ attachments must be attached and locked onto the
ISOFIX anchor points.
Check to make sure the child restraint is securely installed by pulling on
the both ISO Connector™ attachments.
3
- Press the ISO Connector™ adjustment button and push the child restraint
back against the vehicle seat until tight. (28)
Removing and storing ISO Connector™ attachments
1
- To remove from the vehicle, press the ISO Connector™ adjustment button
(29)-1 and pull the base away from the seat. (29)-2
2
- Then press and release the connectors from the vehicle's ISOFIX. (30)
3
- To retract the ISO Connector™ attachments into the base press the
ISO Connector™ adjustment button. (31)
Securing your Child in the Child Restraint
For installation with 3-point-belt
1
- Please check whether the vehicle shoulder belt guides are at proper height
when the child is in the child restraint.
2
- Position the shoulder belt through the shoulder belt guide and pass the
waist belt through the vehicle waist belt slots. Engage the vehicle buckle
and pull the vehicle belt to make sure it is tightened. (32)(33)
13
TRES instructions
Shoulder belt must pass through shoulder belt guide.
Waist belt must pass through waist belt slots.
The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
Never use a vehicle waist-only belt across front of child.
DO NOT use shoulder belt loose or positioned under arm.
DO NOT use shoulder belt behind child's back.
DO NOT allow child to slide down in the child restraint in case of
strangulation.
For installation with 3-point-belt and ISO Connector™
1
- Installation with ISO Connector™ attachment is as (24) - (28).
2
- Place the child in the child restraint and check whether the shoulder belt
guides are at proper height.
3
- Installation with 3-point-belt is show as (32)(33).
4
- Correctly assembled 3-point-belt and ISO Connector™ attachment is
shown as (34).
Make sure that both ISO Connector™ attachments are securely attached
to their ISOFIX anchor points. The colors of the indicators on both ISO
Connector™ attachments should be completely green. (34)-1
Check to make sure the child restraint is securely installed by pulling on
both ISO Connector™ attachments.
Shoulder belt must pass through shoulder belt guide. (34)-3
Waist belt must pass through lap belt guides.
The child restraint can not be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the child restraint securely. (34)-2
Never use a vehicle waist-only belt across front of child.
DO NOT use shoulder belt loose or positioned under arm.
DO NOT use shoulder belt behind child's back.
DO NOT allow child to slide down in the child restraint in case of
strangulation.
14
TRES instructions