Crossover Adjustment (X-Over); Non-Fader Phase (Non-Fader) - Eclipse CD3100 Manuel D'utilisation

Press the [SELECT] (Right/Left)
3
button to adjust the frequency level.
Each time the button is pressed, the
frequency level changes as follows.
When the BASS is selected:
60Hz ↔ 80Hz ↔ 100Hz ↔ 120Hz
When the MIDDLE is selected:
700Hz (FIX)
When the TREBLE is selected:
7.5kHz ↔ 10kHz ↔ 12.5kHz ↔ 15kHz
Press the [EQ/MENU] or [RTN]
4
button to exit sound adjustment
mode.
ATTENTION
• Center frequencies and Q curves adjusted
here are reflected on BASS, MIDDLE and
TREBLE in the audio control mode. (Refer
to page 38 for details on audio control
operation.)
• When the center frequencies and Q curves
are adjusted, CUSTOM EQ will be updated.

Crossover adjustment (X-Over)

Allocate specified frequency bands to each
speaker for improved sound integration.
• Crossover FR adjustment (X-OVER FR)
Sets the frequency for front and rear
speakers.
• Crossover NF adjustment (X-OVER NF)
Sets the frequency for Non-Fader (sub-
woofer).
Press the [SELECT] (Upper/Lower)
1
button to select the X-OVER FR or
X-OVER NF.
2
Press the [ENTER] button.
The selected
activated.
setting mode is
How to operate the Sound Adjustment Mode
Press the [SELECT] (Upper/Lower)
3
button to set PASS or ON.
When the button is pressed, the
setting item changes as follows.
Upper: PASS
Lower: ON
Slope is 12dB/oct under ON.
Press the [EQ/MENU] or [RTN]
4
button to exit sound adjustment
mode.
ATTENTION
Crossover setting will be reflected in the display.

Non-fader phase (NON-FADER)

The merging of sound between the front and rear
speakers and the woofer can be improved.
Switch the phase to a phase which lets the
speakers combine without any disharmony.
Press the [SELECT] (Upper/ Lower)
1
button to select the NON-F.
2
Press the [ENTER] button.
The non-fader
activated.
Press the [SELECT] (Upper/Lower)
3
button to
REVERSE.
When the button is pressed, the
setting item changes as follows.
Upper: NORMAL
Lower: REVERSE
Press the [EQ/MENU] or [RTN]
4
button to exit sound adjustment
mode.
setting mode
select NORMAL
IX
is
or
43