How To Operate The Cd/Mp3/Wma Player; About Compact Discs; About Brand New Cds - Eclipse CD3100 Manuel D'utilisation

How to operate the CD/MP3/WMA player

About compact discs

• The signal recorded on a compact disc is read by a laser beam, so nothing touches the disc surface.
A scratch on the recorded surface or a badly warped disc may cause deteriorated sound quality or
intermittent playback. Observe the following precautions to ensure high quality sound performance:

About brand new CDs

Rough Edges
Ballpoint pen
Rough Edges
Flakes
Recorded surface
• Do not leave an ejected disc in the disc slot for very long; the disc may
warp. Discs should be stored in their cases and kept away from high
temperature and humidity.
• Do not stick a piece of paper or tape. Do not write on or scratch either
side of a disc.
• Discs spin at a high speed inside the main unit. Keep cracked or
warped discs out of the player to avoid damage it.
• Avoid touching the recorded surface when handling a disc; handle
discs by their edges.
• You may notice that some brand new discs are rough around the
center hole or outside edge. Remove the rough edges with the side of
a ballpoint pen, etc. Rough edges may prevent proper loading in the
main unit. Flakes from the rough edges may also stick to the recorded
surface and interfere with playback.

How to operate the CD/MP3/WMA player

III
IV
19