Preparing The Ice Machine For Storage - AGA marvel 30iMT Instructions D'installation, D'utilisation Et D'entretien

Is the distributor tube restricted? Check the water line to
the ice machine to make sure there are no restrictions or
kinks in the line. Check all filters to make sure they are
not restricted. Check that the water flows evenly out of the
distributor tube, if not, clean the ice machine. See "Clean-
ing the Ice Machine".
Plumbing Problems
Is the drain hose aligned over the drain? Move the ice
machine to align the drain.
Is the ice machine draining properly? Check that there are
no kinks or restrictions in the drain lines; this can cause
water to back up in the ice bin. Check that foreign material
is not blocking the ice bin drain located at the right rear
corner of the ice bin. Check the drain pump discharge and
vent line or any restrictions or kinks. Check that the drain
pump is level.
NOTE
If there are plumbing issues outside of the ice machine,
they cannot be repaired by the service technician. A quali-
fied plumber will have to be called.

Preparing the ice machine for storage:

If the ice machine is moved, not used for an extended
period of time, or will be in an area that will be near freez-
ing temperatures, it is necessary to remove any remaining
water in the ice-making system.
This ice machine must have all water drained and removed
to prevent ice machine damage as well as possible water
damage to the surrounding area in freezing conditions.
These damages are not covered under warranty.
Do not use any type of anti-freeze or other solution as a
substitution for properly draining the ice machine.
Clean the Ice Machine
Cleaning the ice machine will help prevent mold and mil-
dew growth as well as sanitize the ice machine for storage
or when it is put back into service. See page 17 for instruc-
tions for cleaning the ice machine.
TROUBLESHOOTING GUIDE
PREPARING THE ICE MACHINE FOR STORAGE
Risk of electrical shock or personal injury could occur due
to moving components, if machine compartment access
cover is removed before unplugging the ice machine.
Draining and Removing Water from the Ice-
Making System with a Gravity Drain.
1. Turn off water supply to the ice machine.
2. Disconnect the water supply fitting at the inlet of the
water valve.
3. Switch the rocker switch to CLEAN for approximately
one (1) minute. This will energize and open the water
valve and remove most of the water from the water
valve and the water valve's outlet water line to the
reservoir.
4. Switch the rocker switch to OFF position. This will
energize and open the drain valve to drain the reservoir
and the ice machine drain system.
5. Unplug the ice machine from the electrical outlet.
6. Remove the access cover from the rear of the ice ma-
chine. (See page 6).
7. Disconnect the water valve's outlet water line to the
reservoir and drain the remaining water left in the water
line trap area. See Figure 26a.
8. Reconnect the water valve outlet water line. See Figure
26a.
9. Reinstall the ice machine's access cover.
10. Clean and dry the ice machine's storage bin.
11. Prop the door open for air circulation to prevent mold
and mildew.
12. Leave the water supply line disconnected or reconnect
the supply line and leave it shut off. Do NOT turn the
water on and allow water to enter back into the water
valve.
Draining Water for Factory Installed Drain
Pump Applications
Follow steps 1 through 12 for the gravity drain then do the
following:
13. Remove the drain pump from the ice machine (refer to
drain pump removal instructions on page 24).
14. Drain the water in the drain pump's reservoir by turn-
ing the pump upside down and allowing water to drain
through the pump's inlet and vent tube fittings.
15. After all water is drained, reinstall the drain pump.
Make certain all tubing is installed and all hose clamps
are tight (refer to drain pump removal instructions on
page 24).
22