Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FILLER PANEL KIT INSTALLATION INSTRUCTIONS (OPTIONAL)
Filler Panel Kit
This Filler Panel Kit will add 3 inches to the width of the ice
machine for installation into an 18 inch wide opening. Order
one of the following part numbers for the color you require:
P/N 42242831 White Filler Panel Kit
P/N 42242832 Black Filler Panel Kit
P/N 42242833 Stainless Steel Filler Panel Kit
Optional Filler Panel kit includes the following:
quantity 2 Cabinet Extensions
quantity 2 Kick plate Extensions
quantity 6 #10 x
⁄
" sheet metal screws
1
2
The following tools are needed:
Phillips screwdriver
Scribe or sharp pointed object
Sharp
⁄
" diameter drill bit and drill.
1
8
To install the filler panel kit:
1. Hold one cabinet extension to side of the ice machine,
keeping the
⁄
" diameter holes to the outside. Line up
1
2
the top and front of the cabinet extension with the top
and front of the ice machine. Mark the 3 hole locations
with the scribe.
2. Drill the scribed hole locations with the
bit. DRILL ONLY ENOUGH TO GO THROUGH THE
CABINETS OUTER SKIN. Do not drill past this point or
you will drill to the inside of the ice machine.
3. Reposition the cabinet extension to the ice machine
and screw in place with 3 of the sheet metal screws.
DO NOT OVER TIGHTEN THE SCREWS.
4. Repeat steps 1 through 3 for the other side of the ice
machine.
5. Remove the screws securing the grille to the bottom of
the ice machine. Slide the kick plate extensions behind
the grille as shown. Replace the screws and tighten.
ENERGY SAVING TIPS
Energy Saving Tips
The following suggestions will minimize the
cost of operating your ice machine appliance.
1. Do not install your appliance next to a hot appliance,
(cooker, dishwasher, etc.). heating air duct, or other
heat sources.
2. Install product out of direct sunlight.
3. Assure the front grille vents at front of the ice machine
beneath the door are not obstructed and kept clean to
allow ventilation for the refrigeration system to expel
heat.
4. Plug your appliance into a dedicated power circuit. (Not
shared with other appliances).
5. Minimize door openings and duration of door openings.
6. Set the control to the "off" position if cleaning the ice
machine requires the door to be open for an extended
period of time.
⁄
" diameter drill
1
8
20
(45.7cm)
Figure 23
Publicité
Chapitres
Table des Matières
Dépannage
