AGA marvel 30iMT Instructions D'installation, D'utilisation Et D'entretien page 15

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
Top hinge
adapter
Figure 11
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the
screw pilot holes for attaching the overlay panel to the door.
Select the size of the hole from Table C. Be careful not to
drill the pilot holes through the overlay panel, (
deep for ⁄ " (19mm) and
3
4
panels ).
Step 7: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay
panel to the door. (See Figure 12).
Step 8: Install door gasket
Press the door gasket into the door channel. Make certain
the gasket corners are fully inserted. If applicable insert
the key into the lock and make certain the lock operates
properly.
Step 9: Install the door
Install the top and bottom hinge adapter bushings back into
the hinge adapters that were removed in step 6. Install the
door by reversing the procedure from step 2. Install the top
hinge pin so the screw head is flush with the top surface of
the hinge. If applicable insert key into lock and verify the
lock cam works properly with the catch bracket on the front
of the ice machine cabinet.
Hole in
hinge
adapter
Door
Overlay
panel
Hole in bottom
hinge adapter
⁄ " (12.7mm)
1
2
⁄ " (15.7mm)
5
8
Material Type
Hardwood
Softwood
Clearance hole through
door gasket channel
#10 Wood Screw
Back of door
Top hinge pin
Top door hinge
adapter
Top hinge adapter
bushing
Bottom door
hinge adapter
Bottom hinge
adapter bushing
Bottom hinge
cam
Bottom hinge pin
15
#8 Wood Screw
⁄ " (3.2mm) Diameter. Pilot Hole
1
8
⁄ (2.8mm) Diameter. Pilot Hole
7
64
Table C
Figure 12
Top hinge
Figure 13
Right hand
hinges shown
Bottom
hinge