AGA marvel 30iMT Instructions D'installation, D'utilisation Et D'entretien page 18

OPERATION, CARE, AND CLEANING OF YOUR ICE MACHINE
4. Remove the drain plug at the bottom of the reservoir to
drain any remaining water and then reinstall.
Figure 19
5. Allow the ice to fall from the evaporator, remove and
discard slab of ice. (See figures 20 and 21).
Figure 20
Remove ice
slab and
discard
Drain plug
in bottom of
reservoir.
Allow ice slab
to fall on to
grid cutter
Figure 21
6. Determine the proper amount of cleaner from the ice
machine cleaner manufacturer's mixture ratio based on
gallon (2.81 liters) of water (refer to the manufacturer's mix
ratio directions). Check to be sure the reservoir drain plug
is installed that was removed in step 4. Add the recom-
mended amount of concentrated cleaning solution to the
reservoir of the ice machine. This can be done by pouring
the solution on the evaporator, which will flow down into the
reservoir. (See figure 22).
7. Switch the selector switch on the grille of the ice
machine to the "CLEAN" position. The ice machine will
automatically start and stop the cleaning cycle and ¾ of a
gallon (2.81 liters) of water will automatically be added to
the cleaning solution.
8. The total cleaning time will end in 49 minutes. The
cleaning cycle will automatically rinse the evaporator plate
and also drain the cleaning solution and rinse the reservoir
with water.
9. After the cleaning cycle has ended check that the build-
up has been removed. The evaporator plate should be
clean, shiny, and smooth to the touch. If build-up is still
visible, repeat the cleaning cycle above.
10. Clean the ice machine's interior, ice scoop, interior door
panel, plastic splash shield and door gasket with mild soap
and water. Using two (2) tablespoons of baking soda in one
(1) quart of warm water while cleaning will help remove
odors. Rinse with fresh water.
DO NOT USE ANY ABRASIVE CLEANING PROD-
UCTS.
11. Replace the front panel.
12. Your ice machine is now clean and sanitized and may
be put back into operation by switching the selector switch
to the "ON" position.
NOTE
the unlikely event a power interrupt occurs during the clean
cycle, you need to start over from the beginning to assure
complete cleaning and rinsing of the cleaning agent from
the machine.
18
Figure 22
Discard the first batch of ice. In
⁄
3
4