Publicité
Les langues disponibles
Les langues disponibles
Technical data and certification
1
Technical data
1.1 Keyboard
Bezeichnung/Designation/
Désignation
Spannungsversorgung/Power supply/
Tension d'alimentation
Stromaufnahme/Current consumption/
Consommation de courant
Lagertemperatur/Storage temperature
range/Température de stockage
Betriebstemperatur/
Operating temperature range/
Température de fonctionnement
Abmessungen/Dimensions/Dimensions 458 x 195 x
1.2 Chip card reader
Bezeichnung/Designation/
Désignation
Kartenleseeinheit/Card reading unit/
Lecteur de carte
Protokolle/Protocols/Protocoles
2
Certification
2.1 Hinweis zum GS-Zeichen
Aufgrund der Position der Nulltaste des Nummernfelds ist
die Tastatur für Saldiertätigkeiten, die überwiegend blind
erfolgen, in Deutschland nicht anzuwenden. Eine Tastatur
mit nicht-deutscher Tastenknopfbelegung ist in Deutschland
aufgrund der Zeichenbelegung (DIN 2137 Teil 2) nicht für
den Dauereinsatz an Bildschirmarbeitsplätzen zu verwen-
den.
4
2.2 Federal Communications Commission (FCC)
Information to the user: This equipment has been tested and
Wert/Value/
found to comply with the limits for Class B digital device,
Valeur
pursuant to Part 15 of the FCC Rules. These limits are
+5 V ±5 % SELV
designed to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
max. 100 mA
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
–20 °C – +60 °C
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
0 °C − +50 °C
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
60 mm
•
Reorientate or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the equipment into an outlet on a circuit different
Wert/Value/
from that to which the receiver is connected.
Valeur
•
Consult the dealer or an experienced radio/
100 000 Steckzy-
TV technician for help.
klen/insertions/
cycles d'insertion
Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could void
T=0, T=1, S=8,
the user's authority to operate the equipment.
S=9, S=10
2.3 For UL
For use with Listed Personal Computers only!
2.4 VCCI Statement
Radio Frequency Interference Statement
Publicité
