Thermador PROFESSIONAL PRO HARMONY PRG304GH Manuel D'installation page 27

Griddle Tilt Adjustment
If the range is equipped with an electric griddle, check the
griddle frame adjustment by pouring two tablespoons of
water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the frame. Start with one half turn
counterclockwise (CCW) of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Figure 26: Griddle Leveling Screws
WARNING!
To avoid risk of injury, never operate the griddle without
the griddle plate installed. Never use griddle in a manner
that is not prescribed by the Use and Care Guide.
The griddle plate must always be in place when the
griddle is turned on.
Assembling the Grill (not all models)
Refer to "Using the Electric Grill" in the Use and Care
Guide.
English 24
(not all models)
Move griddle Move griddle Move griddle
plate to the side plate to the side plate to the side
and turn leveling and turn leveling and turn leveling
screws screws screws
Adjusting the Kick Panel
To adjust the kick panel do the following:
1. Remove the kick panel screws using a T-20 Torx
screwdriver.
2. Relocate kick panel at one of the five screw hole
positions, as noted below. Reinstall Torx screw.
Kick Panel Kick Panel Kick Panel
Adustment Adustment Adustment
Holes Holes Holes
3. Repeat with the remaining kick panel screws, assuring
kick panel is level.
• The range kick panel should maintain a minimum
½" (12.7 mm) clearance above the floor.
Figure 27: Kick Panel Adjustment