Operating Mode Auto - Kübler CODIX 533 Mode D'emploi

2. Functions
– see page 9
– SiGnal allows selecting
the setpoint output in volts or mA.
Press both keys to switch over from
SiGn to ou.Lo and ou.HI.
– output.Low allows defin-
ing the lowest value.
– output.High allows
defining the highest value.
– StEP allows defining
the increment. During operation,
the setpoint output will increase by
this value when the right key is
pressed. The setpoint output will
decrease by this value when the
left key is pressed. During opera-
tion, if the operator tries to reduce
the setpoint below the low limit, the
setpoint will be maintained at the
value of ou.Lo.
If he tries to exceed the upper
limit, the setpoint will be main-
tained at the value of ou.Hi.
Note
If, during operation, the operator
switches to the programming mode
and alters the value of ou.Lo, ou.Hi,
di.Lo or di.Hi, the parameter StEP
will be reset to zero and the output
value will be reset to ou.Lo or di.Lo.
3. After setting the value of StEP,
press both keys simultaneously;
the following message is displayed:
www.kuebler.com
4. Use the right key to select YES or
no
⇑
5. If YES is selected, press both
keys simultaneously to end the
programming
⇑ ⇑
6. The device is ready for operation.

4.2.3 Operating Mode Auto

1. The following parameters can be
programmed for the Auto mode:
A
see page 9
to
to
to
7