Programming; Programming Switching Times - Siemens DELTA i-system Komfort 5TC1 Serie Notice De Montage Et De Service

Programming the switching times

6. Programming

6.1 Programming the switching times
Info: If an UP and a DOWN command are programmed to be executed on the same
weekday and at the same switching time, only the UP command will be executed.
Example:
Setting the current data
Programming memory A
Programming memory B
Programming memory C
Mo 8.15 executed
Mo 8:15 not executed
Time
Setting the sun / twilight value
Shifting astro times
Learning louver running time
1. Activating the programming mode:
Depress until prog is displayed.
Set
With this key, programming can also be interrupted
during the programming of steps 1 - 7 .
In this case, the data are incomplete and not
stored.
2. Selecting the program memory
Use the or
, or in which the new switching times are
A B C
to be stored.
Confirm your choice by depressing
The shutter control timer 'Komfort' is now ready to
accept the input of new switching times.
keys to select program memory
GB
briefly.
Set
45