Setting Actuale Data - Siemens DELTA i-system Komfort 5TC1 Serie Notice De Montage Et De Service

GB
4.3. Setting the actual data
Time
Setting the current data
Programming memory A
Programming memory B
Programming memory C
Info: If no key is pressed for more than 2 minutes in the programming mode, the timer
quits this mode and switches over automatically to displaying the actual time.
Inputs not confirmed with the
The programming mode can be interrupted at any time by prerssing
than 3 seconds.
40
Setting the sun / twilight value
Shifting astro times
Learning louver running time
key by this time will be disregarded.
Set
To put the shutter control timer 'Komfort' into
operation, enter the actual data as follows
(date/hour):
1. Keep the key depressed until prog appears
Set
on the display.
2. The keys
following settings (see diagram):
Hour/date l
: setting of actual data
: programming of memory A
: programming of memory B
: programming of memory C
: storing of shutter run times
Astro l
: setting of shifts Astro time shifts
: setting of sunset/twilight
brightness
3. Select the date/hour symbol with the
keys
4. Confirm the selection of the date/hour function
by pressing
Set
The timer attachment is now in the actual data
set mode
Setting the actual data
or are used to select the
Set
briefly
for more
or