Intenza 550GC Serie Manuel Du Propriétaire page 9

EN
WARNING Do not remove warning tape from the sliders
prior to the handlebar being assembled.
After assembly, remove the warning tape. Do not move
horizontal slider backwards.
8
550GC Series Cycle Assembly Instructions
STEP 5
Assemble the handlebar
COMPONENTS AND TOOLS
Screw, countersunk (16)
PLEASE NOTE
In order to avoid damaging the interior cabling, the
handlebars must not to be adjusted horizontally before this
step.
Ensure that bolts are tightened with sufficient force (30Nm)
when mounting the handlebars. The fastening counter sunk
bolts are coated with TufLok® at the factory to prevent
them from becoming loose during use. If bolts are loosened
after initial assembly, we recommend using medium—strength
LOCTITE 2701 when reassembling.
®
STEP 6
GC—Assemble the Cap, end, track, HB, rear
COMPONENTS AND TOOLS
Tapping screw, M4 x 8L (15)
STEP 7
Assemble the handlebar
COMPONENTS AND TOOLS
Screw, countersunk (16)
PLEASE NOTE
Set the vertical adjustment of the handlebar stem to the
highest position before beginning with assembly.
Intenza 550GC Series Cycle Handbook: 550GC Series Cycle Assembly Instructions