Preventive Maintenance - Intenza 550GC Serie Manuel Du Propriétaire

EN
PLEASE NOTE
Replace defective components immediately
or keep the equipment out of use until the equipment
undergoes repair.
18

Preventive Maintenance

WARNING
· Please carefully observe the following instructions. The maintenance and care procedures set out must be performed regularly to
ensure maximum operating safety and lifespan. Irregularly observed maintenance and care procedures will lead to increased wear to
the product and will void the warranty. If you have any further questions on this topic, please contact our technical support.
· Please use only acid and solvent—free maintenance and care agents (e.g. Brunox) as recommended by us, to prevent damage to
550GC Series components.
· Depending on the use and maintenance of the product, certain items can be replaced on a scheduled basis. We recommend that you
replace the belt and pedals every two years in order to keep the bike in top working order.
· Any other servicing should be performed by an authorized service representative.
DAILY MAINTENANCE
· Make sure that 550GC Series is leveled and does not rock
· Cleaning: 550GC Series Cycle must be regularly cleaned after each use for reasons of hygiene. Ensure that there are sufficient soft
cloths or paper towels, maintenance and disinfection agent available. First disinfect the saddle and handlebars with a suitable
agent and then wipe all bodily residues off the entire 550GC Series Cycle.
WEEKLY MAINTENANCE
· Cleaning: Depending on how often 550GC Series Cycle is used, it must be extensively cleaned once a week. To do this, spray a
maintenance agent onto a soft cloth and clean all plastic parts, the entire flywheel, exposed framework parts including stabilisers
and the plastic casing.
· Never spray the maintenance agent directly onto the flywheel, as this could cause the drive belt to slip through (belt slip) and may
have a negative impact on E—brake functionality.
Troubleshooting
CHECKLIST
· Verify the symptom/s and review the operating instructions.
· The problem may be unfamiliarity with the product, its features or the workout programs.
· Check the error message, then follow the instructions in the service manual.
· If the problem you encounter has not been solved by the above steps, and the Intenza 550GC Series Cycle is still not operational,
locate and document the serial number of the unit, and contact your local dealer.
WHERE IS THE SERIAL NUMBER OF THE PRODUCT
The serial number contains six digits, and there is one location you can find Intenza 550GC Series serial number—
· Located on the bottom that near main body.
Intenza 550GC Series Cycle Handbook: Preventive Maintenance