Traktor 3 Le Controller Mapping - Numark OMNI CONTROL Guide D'utilisation Simplifié

TRAKTOR 3 LE CONTROLLER MAPPING

24
3
25
11
26
12
27
9
13
5
Please note: This overlay is intended to function with both Traktor 3 LE and Traktor 3. You will notice that a few controls
have been left unlabeled. When using Traktor 3, you can assign these controls to various different functions in the
software. If you are using the Traktor 3 LE version included with the Omni Control, you will notice that these controls have
been already mapped to certain functions in the software. Please see below for explanation of these controller mappings.
1. TRACK - You can use the TRACK knob to scroll
through the music on your computer. Press down
on the TRACK knob to load the selected track in
the preview player.
pressing and holding down the PAGE button to
browse and navigate through your different drives,
folders and playlists. Once you release the PAGE
button, you can then use the TRACK knob to
browse the contents of the selected folder.
2. PAGE - Holding down the PAGE button while
using certain controls on the Omni Control allows
for an additional layer of functionality.
3. CUE SOURCE - Press the CUE SOURCE button
to send the music playing on the deck to the
Monitor channel. Please note that if you are not
using a multiple output audio interface, the Monitor
(headphone) channel will be the same as the
Master channel.
structure on the left of the screen, while holding
down the PAGE button, you can use the CUE
SOURCE buttons to expand and collapse the
selected folder. The left CUE SOURCE button will
collapse the selected folder, while the right CUE
22
15
23
16
28
16
29
16
10
17
14 7
8
6 4
Use the TRACK knob while
When browsing the folder
22
15
19
23
16
21
32
16
33
20
16
1
17
14
2
8
18 5
SOURCE button will expand the selected
folder.
4. PLAY - Press the PLAY button to begin playing
the track.
5. CUE - The CUE button will return and pause
the track at the last set cue point.
temporary play of the cue point, you can hold
down the CUE button. The track will play for
as long as the button is held down and will
return to the cue point once it has been
released.
6. SET CUE - You can use this button to set a
new cue point.
7. CUE PLAY - You can hold down the CUE
PLAY button to go back and pause at the last
set cue point.
PLAY button, the track will begin playing.
8. VOLUME - Each virtual deck features a
VOLUME fader which can be used to make
volume adjustments to the music playing on
the corresponding deck.
9
30
3
31
11
34
12
35
9
10
7
13
6 4
When you release the CUE
For