Programming; Interface Description; Key Description; Description Of Parameters And Screens - Italtecnica CRONO SPY Manuel D'instructions

PROGRAMMING:

INTERFACE DESCRIPTION

1. Display with status indicator,
error display, configuration menus.
2. Programming keys
3. Green mains power ON indicator light (LINE)
4. Red error indicator light (FAILURE)
5. Yellow "pump running" indicator light (PUMP ON)

KEY DESCRIPTION

Arrow/reset: scrolls forward through menus and performs unit reset in the event of alarms and/or
errors
"+" key: increments the parameter value currently on display; enables
manual operation of device (overrides pump start-up even outside programmed ON period)
"-" key: decreases the parameter value currently on display; shows the absorbed current (optional)

DESCRIPTION OF PARAMETERS AND SCREENS

USER PARAMETERS:
These parameters are normally accessible when the device is powered.
device automatically returns to automatic mode, indicated by the text AUTO appearing on the display.
Main screen: during normal operation of Crono Spy, the display shows the
device status. The top line displays the current day of the week (G1) and the
current time (08:00). The lower line shows the daily programming status
(ON and OFF periods) and the current operating mode (AUT for automatic
and MAN for manual).
Manual mode: if the user needs to start the pump, also outside the
programmed ON period, simply press the "+" key on the main screen to
switch the device to manual mode, indicated by the message MAN
appearing on the display. The pump is started and runs until the water flow
runs out. After shutdown of the electric pump due to lack of water flow, the
24
1
4
5
3
2