Maintenance - Gardena SmallCut 300 Accu Mode D'emploi

7. Maintenance

Risk of Injury !
Risk of Injury !
Cleaning the cover and the
ventilation slots:
Replacing the filament
cassette:
18
19
14
There is a risk of injury from the cutting filament!
Always remove the battery pack of the Turbotrimmer before
carrying out maintenance work!
Risk of injury and risk of damage to property !
Never clean the Turbotrimmer under running water or with a
water jet (in particular a high pressure water jet).
The ventilation slots must always be free of dirt.
16
After each use remove grass and dirt residue from the cover (4)
and the ventilation slots (16).
4
Risk of injury !
Never use metallic cutting elements or replacement parts
and accessories not provided by GARDENA.
Risk of injury from the filament limiter !
Only use original GARDENA Filament Cassettes. You can order
Keep fingers away from the filament limiter
Replacement Filament Cassettes from your GARDENA dealer or
After replacing the filament cassette always return the trimmer
directly from the GARDENA Customer Service.
to its normal operating position before switching on.
17
• Filament Cassette for Turbotrimmer SmallCut 300 Accu:
Art. 5306
18
1. Remove the battery pack.
2. Release the cassette cover (17) by pressing both locking clips (18)
and remove the cover.
3. Remove the filament cassette (19).
4. Remove any dirt.
20
5. Feed the cutting filament (5) of the new filament cassette (19)
through the hole (20) and pull out about 10 cm.
5
6. Insert the filament cassette (19). Do not trap the cutting filament (5)
when you do this.
7. Fit the cassette cover (17) so that you hear both locking clips (18)
click into place.
If the cassette cover (17) does not lock into position, turn the
filament cassette (19) slightly, until the filament cassette (19) is
correctly located in the filament cassette holder.
Check the cassette cover (17) is correctly fitted by trying to
remove it without pressing the locking clips (18).