Télécharger Imprimer la page

Assembly; Initial Operation - Gardena SmallCut 300 Accu Mode D'emploi

Masquer les pouces Voir aussi pour SmallCut 300 Accu:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

3. Assembly

3
2

4. Initial Operation

6
9
12
1. Fit the upper part of the handle (1) and the lower part of the
trimmer (2) together until they click into place. The internal cable
must not be stretched or trapped when doing this.
1
2. Put the additional handle (3) onto the upper part of the handle
(1) until it clicks into place.
3. Put the cover (4) onto the lower part
of the trimmer (2) while feeding the
cutting filament (5) through the
opening in the cover (4).
4. Put the cover (4) onto the lower part
of the trimmer (2) until the connection
(3 snap fittings) clicks into place.
Before using for the first time, the battery must be fully charged.
Charging time (for uncharged battery) approx. 6hrs.
The NiMH battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
So that the fully charged battery is not discharged, the battery
should be disconnected from the battery charger.
7
8
1. Plug the plug of the charger cable (6) into the battery (7).
2. Plug battery charger (8) into a mains socket.
The charging indicator lamp (9) on the battery charger lights
up red. The battery is being charged.
When the charging indicator lamp (9) lights up green, the battery
is fully charged.
3. First remove the charging cable (6) from the battery (7) and then
unplug the battery charger (8) from the mains socket.
4. Push the battery (7) from the bottom onto the handle (10).
Avoid exhaustive discharge:
Stop using the trimmer before the battery is fully discharged as
7
this shortens the battery life.
If the output of the trimmer decreases noticeably, charge the
battery.
10
If the battery has been totally discharged, the LED will flash at the
start of charging. If the LED is still flashing after an hour, a fault
has occurred (see 8. Troubleshooting).
WARNING !
Overvoltage damages batteries and the battery
charger.
Ensure the correct mains voltage.
Use the charger indoors only.
Do not expose the charger to moisture
5
4
2
19

Publicité

loading

Ce manuel est également adapté pour:

8844