English - Enerpac ZU4 Serie Instructions

Screen 11
MOTOR
4.8
HOURS CYCLES
(See Screen 11.) This screen allows the operator to read the
number of hours (On/Off cycles) the motor has been operated.
Toggle between hours and cycles by pushing either the Down
or Up Arrow buttons. Step forward by pressing the Menu
button. See QRC step #4.
_________________________________________________________
General note for all hour and cycle displays:
HOURS DISPLAYED
- up to 9999.9 the display will show decimal hours
- between 10,000 - 99,999 whole hours will be displayed
(decimal "." is not displayed).
- over 99,999 hours the meter starts over at 0.0 reading
decimal hours
CYCLES DISPLAYED
- over 99,999 cycles the meter starts over at 0
_________________________________________________________
E. "Low Volt" Menu
Screen 12
LOW VOLT
HOURS CYCLES
(See Screen 12.) This screen allows the operator to read the
number of hours the pump has been operated in low-voltage
condition. Step forward by pressing the Menu button. See QRC
step #5.
F. "Advance" Menu
Screen 13
ADVANCE
188
HOURS CYCLES
(See Screen 13.) This screen allows the operator to read the number
of hours (On/Off cycles) the Advance solenoid has been operated.
Toggle between hours and cycles by pushing either the Down or Up
Arrow buttons. Step forward by pressing the Menu button. See
QRC step #6.
.0
G. "Retract" Menu
Screen 14
RETRACT
334
HOURS CYCLES
(See Screen 14.) This screen allows the operator to read the
number of hours (On/Off cycles) the Retract solenoid has been
operated. Toggle between hours and cycles by pushing either
the Down or Up Arrow buttons. Step forward by pressing the
Menu button. See QRC step #7.
H. "Local" Menu
Screen 15
SET
OFF
(See Screen 15.) This screen allows the operator to toggle the local
mode ON or OFF, default is OFF. With Local mode ON, the shroud
buttons replace the pendant buttons as the method to operate the
pump (NOTE: The word "Local" replaces "OK" on the "Normal
Operations" display and the pendant buttons become deactivated).
Local mode will provide operation of the pump if the pendant or
pendant cord is damaged. Toggle Local mode ON or OFF by
pressing the Down (Up) Arrow button. Save setting and step
forward by pressing the Menu button. See QRC step #8.
I. "Language" Menu
Screen 16
SET
With a language shown on the text display the operator can change
the display language by pressing the Down (Up) Arrow buttons. Save
setting and step forward by pressing the Menu button. See QRC
step #9.
8
LOCAL

ENGLISH